Samsung Scanner PRO 89 User Guide

          
              
               
                
                
              
                   
                    
                    
                     
QUICK START  
PRO-89 200 Channel  
ENGLISH  
A
20-514  
VHF/Air/UHF/800MHz Handheld Race Scanner  
Refer to your Owner’s Manual for complete instructions.  
OPERATION  
PREPARATION  
SQUELCH  
Antenna  
TURNING ON THE SCANNER/SETTING VOLUME  
AND SQUELCH  
INSTALLING BATTERIES  
1. Press down on the battery compartment cover then  
slide the cover in the direction of the arrow to remove  
it.  
1. Turn SQUELCH until the indicator points to MIN before  
you turn on the scanner.  
2. If you are using non-  
2. To turn on the scanner, turn VOLUME clockwise until you  
rechargeable batteries, place  
them into the black holder, as  
indicated by the polarity  
symbols (+ and –)  
marked on the holder. Or,  
if you are using  
hear a hissing sound.  
VOLUME  
3. Turn SQUELCH clockwise, just until the hissing sound  
stops.  
Display  
4. To turn off the scanner when you finish, turn VOLUME counterclockwise to OFF.  
rechargeable batteries, place  
them into the yellow holder as  
indicated by the polarity symbols (+  
and –) marked on the holder.  
STORING KNOWN FREQUENCIES INTO  
CHANNELS  
1. Press MAN, enter the channel number (1–200) where you want to store a  
3. Place the battery holder into the battery compartment  
and replace the cover.  
PWR  
frequency, then press PGM.  
DC 9V  
2. Use the number keys and to enter the frequency (including the decimal point)  
you want to store.  
USING AC POWER  
CONNECTING AN ANTENNA  
Attach a size B Adaptaplug to the AC adapter so the tip  
reads positive (+), then insert the Adaptaplug into the  
scanner’s PWR DC 9V jack. Connect the other end of the  
adapter to a standard AC outlet.  
3. Press ENT to store the frequency into the channel.  
4. To program the next channel in sequence, press PGM and repeat Steps 2 and 3.  
1. Align the slots around the  
antenna’s connector with the  
tabs on the antenna jack.  
2. Press the antenna down  
over the jack and turn the  
antenna’s base clockwise  
until it locks into place.  
USING VEHICLE BATTERY POWER  
Attach a size B Adaptaplug to the DC adapter so the tip  
reads positive (+), set the adapter’s voltage switch to 9V,  
then insert the Adaptaplug into the scanner’s PWR DC 9V  
jack. Plug the other end of the DC adapter into your  
vehicle’s cigarette-lighter socket.  
© 2003 RadioShack Corporation.  
All Rights Reserved.  
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.  
RadioShack Corporation  
Fort Worth, Texas 76102  
01A03  
Printed in China  
 

Radio Shack Cordless Telephone ET 685 User Guide
Ramsey Electronics Stereo Amplifier PR100 User Guide
RCA Microwave Oven RMW958 User Guide
Ricoh Printer SP 8200DN User Guide
Roland Electronic Keyboard AT800 User Guide
Roland Switch MSQ 100 User Guide
Samsung Air Conditioner AM C610 User Guide
Samsung Bluetooth Headset B1914B1914 User Guide
Samsung Network Card SADT 100HM User Guide
Sanyo Battery Charger KR 7000F User Guide