Radio Shack Cordless Telephone 43 3575 User Guide

activating and charging your battery pack  
Your phone’s handset comes with a rechargeable nickel metal  
hydride (Ni-MH) battery pack already installed.  
43-3575  
900 MHz cordless telephone  
with caller id/call waiting id  
Before charging the battery for the first time, push the pin for activation,  
located on the bottom of the handset (see label with instructions).  
Once activated, remove the label, and then place the handset in the  
base unit to charge.  
Quick Start Guide  
• Do not plug your phone into the phone line while charging.  
• Charge your phone for 15-20 hours without interruption.  
Please read this user’s guide before  
installing, setting up and using your new product  
Notes  
replacing your battery pack  
Unscrew your battery compartment cover and remove the old battery  
pack.  
Plug the replacement battery connectors (red and black wires) into  
the small, black jack inside the battery compartment. They fit only one  
way.  
Replace your battery cover. To ensure it is securely connected, insert  
the bottom first.  
using your cordless phone  
making and receiving calls  
connecting your phone  
To make a call:  
Plug one end of the supplied long  
modular cord into the TEL LINE jack.  
Pick up the handset.  
Press TALK/ FLASH.  
Listen for the dial tone and dial the  
Insert the supplied AC adapter’s  
barrel plug into the DC IN 9V jack on  
the bottom of the base and route the  
adapter’s cord through the strain relief  
slot on the base.  
TALK/FLASH  
number.  
OR  
Pick up the handset and dial the number.  
Then press TALK/FLASH.  
Plug the other end of the modular cord  
into a modular phone line jack.  
To receive a call:  
If Auto Talk is on, just pick up the handset; and, if Auto Talk is off,  
pick up the handset and press TALK/FLASH.  
Note: Actual product may vary from the images found in this  
document.  
Plug the adapter into a standard AC  
outlet.  
If the handset is off the base and Auto Talk is on, press  
TALK/FLASH, any number, /TONE/< or #/>. Or, if Auto Talk is off,  
Note: Refer to page 8-9 of your User’s  
Note  
Note  
press TALK/FLASH. Refer to page 16 of your User’s Guide for more  
Guide for wall mounting instructions.  
information on the Auto Talk feature.  
©2005. RadioShack Corporation.  
All rights reserved. RadioShack and  
RadioShack.com are trademarks  
used by RadioShack Corporation.  
43-3575  
12A05  
UCZZ01441BZ  
Printed in China  
 

Radio Shack Car Stereo System PLCD9MR User Guide
Radio Shack Two Way Radio TRC 239 User Guide
RCA MP3 Player M21 series User Guide
Samsung Bluetooth Headset GH68 12948A User Guide
Sanyo Cell Phone scp 7500 User Guide
Saturn Automobile 2007 Relay User Guide
Sears Refrigerator 53471 User Guide
Sears Typewriter 090 User Guide
Senco Air Compressor PC201 User Guide
Senco Nail Gun 41XP User Guide